on.this.play
Wall mounts, done properly.
We're a small design studio in London, UK. We make wall mounts — the kind of hardware that usually gets ignored until it's holding something you care about.
It started with a board leaning against a wall for two years. Everything available was either plastic tat or over-engineered and expensive. So we made our own, printed it, tested it, and printed it again. The design philosophy is simple: the mount should disappear and the board should look intentional. No branding on the wall, no unnecessary shapes.
Everything is 3D-printed from 100% recycled plastic in our workshop in London.
The material
Our filament is made from recycled plastic waste — reclaimed, cleaned and re-extruded rather than made from new material. It prints strong, it holds its shape, and it keeps plastic in use instead of in the ground.
It matters because hardware is small, easy to overlook and made in enormous quantities. Getting the small things right is the point.
We're starting with skateboard mounts. More wall displays coming soon.
See the mounts